Yamaha ATS-930 소유자 매뉴얼 - 페이지 6

{카테고리_이름} Yamaha ATS-930에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha ATS-930 17 페이지. Front

페이지 인쇄

Installation

Place the sound bar on a flat surface such as on top of a

TV cabinet.

Cautions

• Do not place the sound bar on/under any other devices such as

BD player in a pile. Doing so may cause a malfunction due to

vibrations.

• Do not touch the grilles (fabric parts) on the front of the sound

bar.

• The sound bar contains acoustic suspension speakers. Do not

place magnetically sensitive items (hard disk drive, etc.) near the

sound bar.

• Depending on your installation environment, it may be better to

connect the sound bar and external devices (such as a TV)

before installing the sound bar.

• Do not place the sound bar within 50 mm (2") of the TV. The wall

mount brackets on the rear panel can be removed as necessary.

Removing the stands

When the sound bar blocks the view of the lower part of the

TV screen or the remote control sensor of the TV, remove the

stands (18 mm [3/4"]) of the sound bar to adjust its height.

HINT

• Use the TV Remote Repeater function (p.12) to transmit TV's

remote control signals via the sound bar.

NOTE

• Keep the stands and screws in a safe place for future use.

Attaching the sound bar to a wall

Cautions

• When installing the sound bar on a wall, all installation work must be

performed by a qualified contractor or dealer. The customer must never

attempt to perform this installation work. Improper or inadequate

installation could cause the sound bar to fall, resulting in personal injury.

• Do not attach the sound bar to a wall that is made of weak

materials such as plaster or veneered woods. Doing so may

cause the sound bar to fall.

• Make sure you use commercially available screws that can

support the weight of the installation (specified in Step 2 on the

right). Using clamps other than specified screws, such as short

screws, nails, and two-sided tape, may cause the sound bar to fall.

How to install on the wall

1 Attach the mounting template on a wall and mark

for the screw holes.

Tapes or thumbtacks

Mounting template (supplied)

Screw

holes

2 Remove the mounting template from the wall,

then install commercially available screws and

supplied spacers (as illustrated below) at the

points marked on the wall.

Spacer (supplied)

7 to 9 mm

(1/4" to 3/8")

2 to 4 mm (1/16" to 3/16")

3 Hang the sound bar on the screws.

Mounting holes

on rear of sound bar

Cautions

• Fix the cables in place where they will not become loose. If your

foot or hand accidentally gets caught on a loose cable, the sound

bar may fall.

• Check that the sound bar is fixed securely after the installation.

Yamaha will bear no responsibility for any accidents caused by

improper installations.

4 mm (#8)

20 mm (3/4")

or more