Yamaha CW118V 소유자 매뉴얼 - 페이지 4

{카테고리_이름} Yamaha CW118V에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha CW118V 11 페이지. Speaker system and subwoofer
Yamaha CW118V에 대해서도 마찬가지입니다: 소유자 매뉴얼 (11 페이지), 소유자 매뉴얼 (11 페이지), 소유자 매뉴얼 (37 페이지)

페이지 인쇄

Connecting the Speakers

I Phone Plug Wiring

Phone plugs for connection to the phone jack inputs should be wired as

shown to the right. Be sure to use proper speaker cable — NOT shielded

instrument or line cable — for all speaker connections.

I Neutrik Speakon NL4FC Plug Wiring

If you will be using the Neutrik connectors for speaker input,

wire the plugs as shown to the right. Be sure to use proper speaker

cable — NOT shielded instrument or line cable — for all speaker

connections.

I Full-range Connection

Each speaker (except for the C112VA/ C115VA) features four input/parallel connectors—two 1/4" phone jacks and

two Neutrik Speakon NL4MP connectors. Use either a phone jack or a Speakon connector to receive input from your

sound system/power ampliﬁer. One of the spare connectors can be used to parallel-connect an additional speaker

(keeping in mind the impedance considerations mentioned below).

MIXING

CONSOLE

Impedance Considerations

When connecting speakers in parallel be sure to check the rated load impedance of the power ampliﬁer. Most power

ampliﬁers are capable of safely driving speakers with minimum impedance of 8 ohms or 4 ohms. A pair of paral-

lel-connected 8-ohm speakers have a total impedance of 4 ohms. Two 8-ohm speakers can safely be paralleled on one

output. 4-ohm speakers, however, should not be parallel-connected with other speakers. These models can be con-

nected in parallel, however, if you are using a power ampliﬁer that can safely drive load impedances of 2 ohms or

lower. Check your speaker impedance on page 7.

GRAPHIC

EQUALIZER

POWER

AMPLIFIER

HOT(+)

1+ : HOT(+)

1– :COLD (–)

Neutrik NL4FC connector

SPEAKER

SYSTEMS

COLD(–)

2– (NO USE)

2+ (NO USE)

SPEAKER

SYSTEMS