Yamaha DHR 12M 소유자 매뉴얼 - 페이지 15
{카테고리_이름} Yamaha DHR 12M에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha DHR 12M 24 페이지. Powered speaker system
페이지 인쇄
General Specifications (English only)
General Specifications
General
System Type
Frequency Range (-10 dB)
Coverage Angle
Crossover Type
Crossover Frequency
Measured Maximum SPL (Peak)
IEC noise@1m
Transducer
LF
Diameter
Voice coil
Magnet
HF
Diaphragm
Type
Magnet
Enclosure
Material, Color
Floor Monitor Angle
Dimensions (W×H×D, with rubber feet)
Net Weight
Handles
Pole Socket
Rigging Points
Optional Speaker Bracket
Amplifier
Amplifier Type
*1
Power Rating
Dynamic
Continuous
Cooling
AD/DA
HPF
DSP Preset
Protection
Speaker
Amplifier
Power Supply
Connectors
Input
Output
Input Impedance
Input Sensitivity (LEVEL: Maximum)
Input Sensitivity (LEVEL: Center)
Maximum Input Level
Controls
Idle Power Consumption
1/8 Power Consumption
Power Requirements
0 dBu is referenced to 0.775 Vrms.
*1 Power rating (120 V, 25°C). This is total value of individual output power.
This value is measured by releasing the software protection.
Dynamic: Total peak power of individual outputs. Measured at minimum load impedance, with protection released.
Continuous: Measured at nominal impedance, with protection activated.
DHR15
2-way, Bi-amp Powered Speaker, Bass-reflex Type
44 Hz–20 kHz
H90° × V60°
FIR-X tuning (Linear Phase FIR Filter)
1.8 kHz
131 dB SPL
DHR15
15" Cone
2.5"
1.4"
1" Throat Compression Driver
DHR15
—
432 × 692 × 405 mm
24.0 kg
Side × 2
35 mm × 2 (0 and 7 degree)
Top × 2, Rear × 1
(Fit for M10 Eyebolts)
—
DHR15
1000 W (LF: 800 W, HF: 200 W)
465 W (LF: 400 W, HF: 65 W)
D-CONTOUR: FOH/MAIN, MONITOR, OFF
Clip Limiting, Integral Power Protection, DC-fault
Thermal, Output Over Voltage, Output Over Current
Input1: Combo × 1, Input2: Combo × 1, RCA PIN × 2 (Unbalanced)
Output: XLR3-32 × 1 (CH1 Parallel Through or CH1+CH2 Mix)
INPUT1: LINE: 10 kΩ, MIC: 3 kΩ, INPUT2: 10 kΩ
INPUT1: LINE: 0 dBu, MIC: -32 dBu, INPUT2: 0 dBu
INPUT1: LINE: +10 dBu, MIC: -22 dBu, INPUT2: +10 dBu
INPUT1: LINE: +24 dBu, MIC: -8 dBu, INPUT2: +24 dBu
LEVEL × 2, LINE/MIC, HPF, D-CONTOUR, THRU/MIX, POWER
18 W
74 W
100 V, 110–120 V, 220–240 V, 110 V/127 V/220 V (Brazil), 50/60 Hz
DHR12M
55 Hz–20 kHz
H90° × V90°
1.8 kHz
129 dB SPL
DHR12M
12" Cone
2.5"
Ferrite
1.75"
1" Throat Compression Driver
Coaxial
Ferrite
DHR12M
Plywood, Black, Polyurea coating
57°
500 × 343 × 454 mm
16.5 kg
Side × 1
35 mm
—
—
DHR12M
Class-D
Fan Cooling, 4 Speeds.
24 bit 48 kHz Sampling
OFF, 100 Hz, 120 Hz, 24 dB/Oct.
Thermal, Output Over Current
DHR10
52 Hz–20 kHz
H90° × V60° (Rotatable)
1.9 kHz
128 dB SPL
DHR10
10" Cone
2"
1.4"
1" Throat Compression Driver
DHR10
—
305 × 494 × 300 mm
15.0 kg
Top × 1
35 mm
Top × 2, Rear × 1
(Fit for M10 Eyebolts)
UB-DXRDHR10
DHR10
700 W (LF: 500 W, HF: 200 W)
325 W (LF: 260 W, HF: 65 W)
18 W
60 W
131