Yamaha DXR8 소유자 매뉴얼 - 페이지 12

{카테고리_이름} Yamaha DXR8에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha DXR8 22 페이지. Dxr and dxs series powered speakers and subwoofers
Yamaha DXR8에 대해서도 마찬가지입니다: 매뉴얼 (12 페이지), 소유자 매뉴얼 (22 페이지), 소유자 매뉴얼 (22 페이지), (영어) 사용 설명서 (22 페이지), (영어) 사용 설명서 (22 페이지), (러시아어) (22 페이지)

페이지 인쇄

Troubleshooting

Symptom

Power does not turn on.

Power suddenly went

off.

No sound.

Sound is interrupted

suddenly.

Sound howls

(feedback)

Each speaker sound

differs

(if multiple speakers

are used)

Sound is distorted

The microphone

volume is too low.

Low and high

frequency are

unbalanced.

*If any specific problem should persist, however, please contact your Yamaha dealer.

DXR15/DXR12/DXR10/DXR8/DXS15/DXS12 Owner's Manual

Possible causes

The power cord is not connected

properly.

The protection system has

operated, shutting down the power

supply.

The cable is not connected

properly.

The LINK MODE switch is set

incorrectly.

The protection system has

operated, muting the output.

A microphone is directed toward the

speaker.

Sound is amplified too much.

The setting of the HPF switch is not

appropriate.

Settings for each speaker differ.

Input volume is excessive.

Output volume is excessive.

The MIC/LINE switch is set to LINE.

The output limiter is active.

Possible solution

Connect the power cord properly.

Turn off the power, wait until the amplifier cools

down, and then turn on again.

Connect to the INPUT jack properly.

If you are using a single DXR, set the LINK

MODE switch to MONO.

Wait until the amplifier cools down. If the device

won't automatically reset itself, turn off the power,

and then on again.

Keep the speaker away from the area where the

microphone picks up sound.

Lower the volume of the input device and locate

the microphone more closely to the sound

source.

Set the HPF switch on 120Hz or 100Hz if you get

feedback in low frequency bands.

• (DXR series) Set the HPF and D-CONTOUR

switches of each speaker to the same

positions.

• (DXS series) Set the POLARITY switch, the LPF

switch, and D-XSUB switch of each speaker to

the same position.

• Lower the volume of the input device to a point

no higher than where the LIMIT indicator lights

occasionally.

• If sound continues to be distorted even if you

turn down the volume to the minimum, set the

MIC/LINE switch to the LINE position (if the

switch is set to MIC).

Use the LEVEL control to lower the output level to

a point no higher than where the LIMIT indicator

lights occasionally.

Set the MIC/LINE switch to the MIC position.

Lower the input level or the output level to a point

no higher than where the LIMIT indicator lights

occasionally.