Yamaha DXS18XLF-D 소유자 매뉴얼 - 페이지 9

{카테고리_이름} Yamaha DXS18XLF-D에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha DXS18XLF-D 31 페이지. Powered loudspeakers/subwoofer
Yamaha DXS18XLF-D에 대해서도 마찬가지입니다: 소유자 매뉴얼 (31 페이지), 소유자 매뉴얼 (31 페이지), 소유자 매뉴얼 (31 페이지)

페이지 인쇄



Power section

!2 [AC IN] jack

Connect the supplied AC power cord here. First, connect

the power cord to this product, then insert the power cord

plug into the AC outlet. When removing the power cord,

perform this procedure in reverse order.

WARNING

Use only the supplied power cord/plug.

CAUTION

Be sure to turn the power off before connecting or

disconnecting the power cord.

Insert the power cord fully until it is locked by the latching

lock mechanism (V-Lock).

Press the V-Lock latch to disconnect the power cord.

!3 Power switch

Turns the power supply on [–] or off [ ].

WARNING

A small amount of current flows even when the

power switch is off. If you will not use the speaker

for a long time, be sure to unplug the power cord

from the outlet.

NOTE

• Depending on the timing when the power switch is turned on/

off, it might take up to 15 seconds for the power to turn on.

• When using multiple devices, we recommend turning each

device on one at a time. If multiple devices are turned on at the

same time, the devices might not start up correctly due to a

voltage drop at the power supply.



Dante section (Dante models only)

!4 Dante jacks

These are etherCON jacks for a Dante network. Both jacks

are primary connections. They can be used for daisy

chain connections. For details, refer to the Reference

Manual.

Use STP (Shielded Twisted Pair) cables to prevent electromag-

netic interference. Make sure that the metal parts of the plugs are

electrically connected to the STP cable shield by conductive tape

or comparable means.

!5 [LINK] indicator

Shows the Dante communication status. Lights green

when an Ethernet cable is connected correctly to the

Dante jack.

!6 [1G] indicator

Lights orange when the Dante network is functioning as

Gigabit Ethernet.

!7 [SYNC] indicator

Lights steady or flashes green according to the Dante

communication status, as shown in the following table.

NOTE

Operating normally as a clock slave

Steady

on the Dante network

Operating normally as a clock mas-

Continuously flashing

ter on the Dante network

Periodically flashing

Incorrect DANTE FS setting

one time

Periodically flashing

Dante network cable not connected

two times

Periodically flashing

Incorrect Dante network connection

three times

Functions