Yamaha DZR10-D 소유자 매뉴얼 - 페이지 19
{카테고리_이름} Yamaha DZR10-D에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha DZR10-D 31 페이지. Powered loudspeakers/subwoofer
Yamaha DZR10-D에 대해서도 마찬가지입니다: 소유자 매뉴얼 (31 페이지), 소유자 매뉴얼 (31 페이지), 소유자 매뉴얼 (31 페이지)
Optional Accessories (sold separately)
Speaker
DZR315(-D)
DZR15(-D)
DZR12(-D)
DZR10(-D)
DXS18XLF(-D)
DXS15XLF(-D)
Troubleshooting
Symptom
Power does not come on.
No sound.
No sound, or
intermittent sound.
Volume becomes low sud-
denly.
Sound is interrupted sud-
denly.
Display goes off after a few
moments.
If any specific problem should persist, please contact your Yamaha dealer.
Cover
SPCVR-DZR315
SPCVR-DZR15
SPCVR-DZR12
SPCVR-DZR10
SPCVR-DXS18X
SPCVR-DXS15X
Possible causes
Time between turning the power on/off is too
short.
Routing is not appropriate.
Dante model
Level is low in DSP.
Dante model
Too many Dante devices in the daisy chain
for the current latency settings.
Protection function is active because the
amp is too hot, triggering the limiter.
Protection function is active because the
amp became hotter, triggering the mute
function.
The speaker units are damaged.
The protection function for the display is
active.
U-bracket
—
UB-DZR15H, UB-DZR15V
UB-DZR12H, UB-DZR12V
UB-DZR10H, UB-DZR10V
—
—
Wait about 20 seconds after turning the
power off before turning it back on again.
On the HOME screen, if there is a signal in the
INPUT meter but no signal in the SP Output
Meter, check if the signal is routed to SP OUT
under ROUTER in the settings.
Check the INPUT level under ROUTER in the
settings, and raise it if it is too low.
With the default setting (1 msec), a single
daisy chain can have up to 10 units. When
connecting more than 10 units, use an L2
switch (that supports Gigabit Ethernet) to cre-
ate branches in the network.
In such cases, THERMAL is displayed on the
HOME screen. To prevent the speaker from
getting hotter, improve the ventilation around
the rear panel and shield the panel from
direct sunlight.
In such cases, MUTED is displayed on the
HOME screen and at the same time the
[POWER] indicator flashes. To prevent the
speaker from getting hotter, improve the venti-
lation around the rear panel and shield the
panel from direct sunlight.
If there is no sound even though MUTED is
not displayed on the HOME screen and there
is a signal in the SP Output Meter, the speaker
units might be damaged. Please contact your
Yamaha dealer.
Press either the main knob or the [
(back) key to return to the normal display.
Wheels
—
—
—
—
SPW-1
SPW-1
Possible solution
]
19