Directechs DB3 사용 설명서 - 페이지 4

{카테고리_이름} Directechs DB3에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Directechs DB3 17 페이지. 2011 subaru outback - 403.subaru2 1.25
Directechs DB3에 대해서도 마찬가지입니다: 설치 매뉴얼 (20 페이지), 설치 매뉴얼 (19 페이지), 설치 매뉴얼 (19 페이지), 설치 매뉴얼 (20 페이지), 설치 매뉴얼 (10 페이지)

페이지 인쇄

Pre-installation and application warnings

This section highlights important information for this specific firmware and will assist in pricing accordingly, as

START

HERE

well as bringing awareness to any operational or vehicle limitations.

Compatibilities and Requirements

T-Harness

T-Harness is not compatible.

compatible

Vehicle Takeover

Firmware notes

Remote Start Ready (RSR):

•RSR installations are not compatible with vehicles equipped with a manual transmission.

•RSR is a function that enables the interface module to remote start the vehicle completely on its own

Consequently, there is no need for an aftermarket or an OEM remote starter in order to start the vehicle from a distance.

SmartStart Compatible: SmartStart is equipped with D2D, which means it can be connected to an interface module and used in

Remote Start Ready (RSR) mode without the use of a remote starter. See "Module programming" for more information.

Doors: To remote start the engine, the hood, hatch and all doors must be closed.

Runtime: It is normal for the key symbol to flash during remote start runtime.

Caution:

In these vehicles, the factory keyless entry module is sensitive to interference and may cease to operate without notice.

Ensure you disconnect the (-) terminal of the battery prior to disconnecting and reconnecting the connectors at the start/stop module

below the steering wheel to avoid damage to the keyless entry module.

Unless specified otherwise, all connectors are displayed from the wire side.

Refer to the Vehicle connections section following the installation diagram.

Footnotes

[1] Hood pin: The installation of an aftermarket hood pin is only required on vehicles that are not equipped with a factory hood pin or if

not supported in data.

[2] Parking lights: Connection required when not supported in data. See the Locating components in the vehicle section for more

information about accessing the parking wiring.

403.MA3 2.42.104 2014 Mazda 3 (Smart Key)

Refer to the Quick Reference Guide section for more details.

Keys required for

Keys required

programming

for operation