Directechs Directed 403.HYUNDAI10 v2.11 설치 매뉴얼 - 페이지 14
{카테고리_이름} Directechs Directed 403.HYUNDAI10 v2.11에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Directechs Directed 403.HYUNDAI10 v2.11 19 페이지. Db3 2020 hyundai santa fe (smart key)
페이지 인쇄
Soft reset
A module reset will only erase the steps perfomed in "Module programming". The firmware and settings flashed to the module
will not be affected.
D2D installation
Connect the 10-pin, 12-pin & 14-pin harnesses to the module. Press and hold the
programming button, then connect the 4-pin D2D harness.
1
OR
W2W installation
Connect the 10-pin & 12-pin harnesses to the module. Press and hold the
programming button, then connect the 14-pin harness to the module.
Wait 3 seconds until the LED turns ON solid orange then release the programming button.
2
The LED turns ON solid red.
Hard reset
Warning Against Executing a Hard Reset!
A hard reset will revert the flashed firmware back to its default factory settings. Depending on the installation, some settings (such
as RFTD and D2D options) may have to be reconfigured. Refer to "Feature and option list".
D2D installation
Connect the 10-pin, 12-pin & 14-pin harnesses to the module. Press and hold the
programming button, then connect the 4-pin D2D harness.
1
OR
W2W installation
Connect the 10-pin & 12-pin harnesses to the module. Press and hold the
programming button, then connect the 14-pin harness to the module.
Wait 3 seconds until the LED turns ON solid orange, and wait 10 more seconds until the
2
LED starts to flash orange and red.
3
Release the programming button. The LED turns ON solid red.
14
403.HYUNDAI10 2.11 2020 Hyundai Santa Fe (Smart Key)
©2022 VOXX•DEI LLC. All rights reserved.
5
th
4
th
1
st
(D2D)
(Button)
(10-pin)
3
rd
1
st
(Button)
(10-pin)
&
Solid
Release
5
th
4
th
1
st
(D2D)
(Button)
(10-pin)
3
rd
1
st
(Button)
(10-pin)
Solid
Release
2
nd
3
rd
(12-pin)
(14-pin)
2
nd
4
th
(12-pin)
(14-pin)
&
Solid
2
nd
3
rd
(12-pin)
(14-pin)
2
nd
4
th
(12-pin)
(14-pin)
&
Flashes
&
Solid