Directechs DIRECTWIRE 403.NISS08 설치 매뉴얼 - 페이지 4

{카테고리_이름} Directechs DIRECTWIRE 403.NISS08에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Directechs DIRECTWIRE 403.NISS08 17 페이지.

Pre-installation and application warnings

This section highlights important information for this specific firmware and will assist in pricing accordingly, as

START

HERE

well as bringing awareness to any operational or vehicle limitations.

Compatibilities and Requirements

T-Harness

T-Harness is not compatible.

compatible

Vehicle Takeover

Firmware notes

Remote Start Ready (RSR):

•RSR installations are not compatible with vehicles equipped with a manual transmission.

•RSR is a function that enables the interface module to remote start the vehicle completely on its own

Consequently, there is no need for an aftermarket or an OEM remote starter in order to start the vehicle from a distance.

SmartStart Compatible: SmartStart is equipped with D2D, which means it can be connected to an interface module and used in

Remote Start Ready (RSR) mode without the use of a remote starter. See "Module programming" for more information.

Security light: Will flash during runtime and turn on solid, then off during takeover procedure.

Power door locks: Will not operate properly if doors are open.

Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the OBDII diagnostic connector.

Refer to the Vehicle connections following the installation diagram.

Footnotes

[1] Hood pin: The installation of an aftermarket hood pin is only required on vehicles that are not equipped with a factory hood pin, or if

not supported in data.

[2] Security Light Interrupt: Only required if Security Light Off does not operate in data.

403.NISS08 1.27 2014 Nissan Altima (Smart Key)

Refer to the Quick Reference Guide section for more details.

Keys required for

Keys required

programming

for operation