Yamaha YSP-3300 펌웨어 업데이트 - 페이지 3
{카테고리_이름} Yamaha YSP-3300에 대한 펌웨어 업데이트을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha YSP-3300 7 페이지. Digital sound projector
Yamaha YSP-3300에 대해서도 마찬가지입니다: 빠른 참조 매뉴얼 (2 페이지), 소유자 매뉴얼 (8 페이지), 소유자 매뉴얼 (49 페이지)
페이지 인쇄
STEP2 CONNECT DIGITAL AUDIO WITH BD/DVD/CD PLAYER
Power off the YSP and BD/DVD/CD player. Then, connect the CD, DVD or BD
player* to your YSP using either optical or coaxial digital cable.
YSP (Rear Side)
Optical
or
Coaxial
*It is recommended to remove all other connection from the player. If the player is
connected to another amplifier/receiver, make sure those components are powered off. Or
else, the loud digital communication sound output during the update could cause damage
to the speakers.
STEP3 ENTER FIRMWARE UPDATE MODE
Confirm that the power of YSP is off. Press and hold the [INPUT] key on the YSP
and while holding that key, power on. "ADVANCED SETUP" will appear on the
front display. Then, press [UP]/[DOWN] key to display "FW UPDATE". After
pressing [ENTER] or [RIGHT] key on the remote controller, current version will
be shown on the front display.
STEP4 Press [UP]/[DOWN] key on the remote controller, "START OK?" appears on the
YSP's front display. Afterwards, press [ENTER] key, "PLAY CDDA!" will appear.
Now your YSP is ready for firmware update.
Firmware Update Procedure for YSP-3300/YSP-4300
INPUT
IR Sensor
DIGITAL IN
BD/DVD/CD Player*
Optical Digital Audio Cable
Coaxial Digital Audio Cable
Page.3 of 7