Ecoplus 1/4 HP 사용 설명서 - 페이지 7

{카테고리_이름} Ecoplus 1/4 HP에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Ecoplus 1/4 HP 12 페이지. Water chillers
Ecoplus 1/4 HP에 대해서도 마찬가지입니다: 사용 설명서 (12 페이지)

USING THE DIGITAL CONTROL PANEL

3-Digit Temperature Display

Setting Water Temperature: To enter a temperature setting, press the SET button and hold

for more than 3 seconds. The previously set temperature will appear on the display. Press the UP

or DOWN key to enter a new temperature setting from 37-90˚F (3-32˚C). To accept, press the SET

button again (or just wait about 8 seconds and it will automatically store your new setting and

revert to normal operation). The actual water temperature displays continuously while the chiller

is working. To Compare Actual and Set Water Temperatures: Press the SET button once. The set

temperature will appear, alternating with a display of the actual water temperature (when actual

water temperature is displayed the "Cooling" indicator light goes OFF – when the set

temperature is displayed the same indicator FLASHES).

Automatic Temperature Control: When the compressor stops for over 3 minutes and water

temperature rises 1˚F above the set temperature, the chiller will automatically restart. Once the

set water temperature is reached, the "Cooling" indicator light will go off and the compressor

will stop. NOTE: The "Cooling" indicator light will also ﬂash if any protection device (see below)

is activated for at least 3 minutes.

SPECIAL FUNCTIONS AND PROTECTION DEVICES

• Temp. Display Adjustment: If necessary, the display of actual water temperature can

be adjusted 2.4˚F (1.5˚C) up or down. Press the UP and DOWN keys at the same time for

6 seconds until the numerical display ﬂashes. Then, press the UP or DOWN keys to adjust.

• Compressor Protection: If the compressor somehow becomes overloaded, a protection

device will automatically shut it off, then attempt a restart after about 3 minutes.

• Sensor Circuit Protection: If the water temperature sensor has an open or broken circuit,

the chiller will shut down and a "P1" or "P2" error message will be displayed.

Operation

"Cooling" Indicator Light

SET

Temperature Adjustment Buttons

DOWN