Directechs DB3 설치 매뉴얼 - 페이지 5
{카테고리_이름} Directechs DB3에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Directechs DB3 10 페이지. 2011 subaru outback - 403.subaru2 1.25
Directechs DB3에 대해서도 마찬가지입니다: 설치 매뉴얼 (20 페이지), 설치 매뉴얼 (19 페이지), 설치 매뉴얼 (19 페이지), 설치 매뉴얼 (20 페이지), 사용 설명서 (17 페이지)
페이지 인쇄
Pre-installation and application warnings
Firmware notes: This section highlights important information for this specific firmware and will assist in
pricing accordingly, as well as bringing awareness to any operational or vehicle limitations.
T-Harness
compatible
Key2GO is mandatory to control the immobilizer override in this firmware.
Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the OBDII diagnostic
connector.
For clutch information, refer to Directwire vehicle information and to tech tip #10000.
Refer to "Vehicle connections" following the wiring diagram.
General notes: This section highlights important information for this specific firmware.
Tach wire is an optional connection required on some remote starters, which do not support a tach signal in D2D.
[1]
Keysense input connection ONLY needed if Keysense is not recognized through data at the time of programming. Refer to
[2]
"LED Diagnostics & Troubleshooting" for more information.
Additional parts required (maximum required):
Diode 6A
0 x 1A Diodes
5
87
87a
86
85
30
1 x Relay
Keys required for
programming
Resistor 100Ω
0 x Resistor
403.SUBARU2 1.25 2011 Subaru Outback
© 2016-12-29 Directed. All rights reserved.
1
Keys required for
0
operation
Fuse 7.5A
0 x Fuse