Clark Cooper EH40 설치 및 운영 매뉴얼 - 페이지 3

{카테고리_이름} Clark Cooper EH40에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clark Cooper EH40 7 페이지.

Built in filters are now being offered.

Sealing:

Six different valve seat leakage classifications are defined by ANSI/FCI 91-2-2004. All valves

must pass a leakage test prior to the leaving the factory based on the requirements of this

specification.

This standard leakage for the EH40 product is Class 2. Class 5 is available.

Electrical:

Electrical wiring must conform to the nameplate rating. Wiring, conduit, and conduit

connections must comply with National and Local Electrical Codes. The standard solenoid

enclosure has a ½" NPT conduit connection. Standard lead wires supplied are 18" long, and are

wire gauge size 18 AWG minimum. The wire used to connect to the power source should be the

same or heavier gauge. Cables extending from ATEX approved coils are 3000mm [118"].

Custom leads lengths may be available upon request.

941 Hamilton avenue

Roebling, nj 08554

www.ClarkCooper.com

Page 3 of 7