Clark Synthesis TST239-Silver 설치 매뉴얼 - 페이지 5
{카테고리_이름} Clark Synthesis TST239-Silver에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clark Synthesis TST239-Silver 8 페이지. Platinum, gold, silver and all weather transducers
Clark Synthesis TST239-Silver에 대해서도 마찬가지입니다: 설치 매뉴얼 (20 페이지)
페이지 인쇄Wiring & Connections
Wiring the Transducer is essentially the same as wiring speakers:
• Use 16AWG or heavier speaker wire.
• Make sure all audio components are OFF before connecting the Transducer.
The diagrams on the following pages show a stereo amplifier powering two Transducers. If only one Transducer
is being used – such as in an individual theater seat – you may use an amplifier that can be bridged to
mono. Typical mono and stereo connections are illustrated below. (Refer to your amplifier's instructions
for bridging.) Be careful not to overpower the Transducer (see power ratings on Page 3).
Powering 1 Transducer with a Bridged Mono Amp
NOTE:
BRIDGED MONO TACTILE AMPLIFIER
Multiple
SPEAKER OUTPUT
AUDIO IN
Transducers
LEFT
RIGHT
are NOT
–
+
–
+
L
R
required for
typical seating
FROM
installations.
AUDIO
SOURCE
Speaker Cable Considerations
The Transducer includes a permanently attached 3-foot speaker wire.
The positive (+) lead is the red wire.
Observe this polarity when conecting your amplifier.
You may need to use solder or wire nuts to attach a length of
speaker cable to reach the amplifier in your audio system. In
any permanent installation, a soldered connection is preferred
because wire nuts may vibrate loose.
Speaker cable size (gauge) should be calculated for run length;
the longer the run, the larger the cable (the lower the gauge).
12 - 14 AWG is recommended; 16 AWG is minimum.
tactile sound transducer
11
Powering 2 Transducers with a Stereo Amp
STEREO TACTILE AMPLIFIER
SPEAKER OUTPUT
AUDIO IN
LEFT
RIGHT
–
+
–
+
L
R
FROM
AUDIO
SOURCE
www.clarksynthesis.com
One of the best materials for carrying tactile sound is wood.
In most applications, the Transducer should be centrally
located on the structure (chair, floor, riser, deck, etc.) in
order to evenly distribute the tactile effect. When two or
more Transducers are used on one structure, they should be
spaced equidistant from each other and the edges/boundaries
of the structure. Mounting to a bridge, joist, or frame member
is preferred.
GENERAL LOCATION DIAGRAM
Transducer mounted to chair frame
Transducer mounted inside riser
NOTE: Transducers are designed to be mounted in a horizontal orientation.
Mounting the Transducer vertically may shorten the Transducer's life.
CORRECT
www.clarksynthesis.com
General Installation Tips
Transducer mounted beneath floor
CORRECT
INCORRECT
tactile sound transducer
4