Clark Synthesis TACTILE SOUND AW339 설치 매뉴얼 - 페이지 7
{카테고리_이름} Clark Synthesis TACTILE SOUND AW339에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clark Synthesis TACTILE SOUND AW339 20 페이지. All-weather transducer
Clark Synthesis TACTILE SOUND AW339에 대해서도 마찬가지입니다: 보충 설명서 (4 페이지), 데이터시트 (1 페이지), 설치 매뉴얼 (8 페이지), 설치 매뉴얼 (2 페이지), 구매자 매뉴얼 (2 페이지), 사양 시트 (1 페이지)
페이지 인쇄Installation Type: T-Nut
Requires initial access to the top of the material to
insert the T-Nut, which installs flush to the surface.
(Drill a 7/16" hole for the T-Nut.)
Minimum 3-1/2" vertical space required,
including 1/2" clearance between the
Transducer and the floor.
3/4"-thick
mounting
surface
Flat Washer
Lock Washer
Transducer Lead Wire
www.clarksynthesis.com
Drill 7/16" hole
T-Nut
NEVER TIGHTEN
BY TURNING THE
Jam Nut (up)
TRANSDUCER.
MAKE SURE TO
3/8"-16
TIGHTEN THE JAM
Threaded Stud
NUT AGAINST THE
Jam Nut (down)
TRANSDUCER'S
BRASS NUT
Washers
Jam Nuts
Installation: Overview
Installation Type: Hex Bolt
For use with metal or other high-tensile mounting
surfaces no thicker than 1/4". Requires access to the
top of the mounting surface both to install the bolt and
to tighten it.
Minimum 3-1/4" vertical space required,
including 1/2" clearance between the
Transducer and the floor.
Maximum 1/4"-thick
mounting
surface
Lock Washer
Transducer Lead Wire
Tactile Sound Transducers
Drill 7/16" hole
3/8"-16
Hex Bolt
Flat Washer
Jam Nut (up)
Jam Nut (down)
Flat Washer
Lock Washer
Jam Nuts
7