Clark Synthesis TST329 설치 매뉴얼 - 페이지 6
{카테고리_이름} Clark Synthesis TST329에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clark Synthesis TST329 20 페이지. Platinum, gold, silver and all weather transducers
Clark Synthesis TST329에 대해서도 마찬가지입니다: 보충 설명서 (4 페이지), 설치 매뉴얼 (8 페이지), 데이터시트 (1 페이지), 구매자 매뉴얼 (2 페이지), 설치 매뉴얼 (20 페이지), 사양 (1 페이지)
페이지 인쇄
Installation: Overview
Installation Type: Unimount Bracket
Screws into the bottom of the mounting surface.
Requires access only to the bottom of the mounting
surface. Requires a flat or nearly flat mounting
surface.
Minimum 4-1/2" vertical space required,
including 1/2" clearance between the
Transducer and the floor.
3/4"-thick
mounting
surface
Unimount
Bracket
Flat Washer
Lock Washer
Screw
Jam Nut (up)
Transducer Lead Wire
Tactile Sound Transducers
6
NEVER TIGHTEN
BY TURNING THE
Transducer. MAKE
SURE TO TIGHTEN
THE JAM NUT
AGAINST THE
Transducer'S BRASS
NUT
3/8"-16
Threaded Stud
Jam Nut (down)
Washers
Screw
Jam Nuts
Installation Type: Hanger Bolt
Screws into the bottom of the mounting surface
(into a 5/16" drilled hole). Requires access only to
the bottom of the mounting surface.
Minimum 3-1/2" vertical space required,
including 1/2" clearance between the
Transducer and the floor.
Minimum
3/4"-thick
Transducer Lead Wire
Tip: Tighten
two jam nuts
against each
other to screw in
hanger bolt using
wrench.
Joist
(edge view)
Drill 5/16" hole
3/8"-16
Hanger Bolt
Jam Nut (down)
Jam Nut
www.clarksynthesis.com