aldes 611242-FC 설치 매뉴얼 - 페이지 3
{카테고리_이름} aldes 611242-FC에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. aldes 611242-FC 3 페이지. Digital multifunction wall control
페이지 인쇄Installation
Material and equipment
•
The multifunction control, the Decora wall plate and its (2) screws (supplied with the multifunction control);
•
The fastening hardware to mount the unit on the wall (not included);
•
Your air exchange system (not included) and its 4-wire cable: yellow, red, green, and blue;
•
A fine flathead screwdriver (non-included) for connecting the wires to the multifunction control.
Installation over an electrical junction box
1. Disconnect the power cable of your air exchange system;
2. Install an electrical junction box (metal or plastic) at the location selected for the multifunction control (Figure 1);
3. Route the cable of your system to the junction box, keeping an extra length of 10 cm (4 in) for the connections;
4. At the end of the cable, strip 50 mm (2.5 in) of the outer sheath to free the four wires;
5. Strip 7 mm (1/4 in) of each wire's sheath. Using the screwdriver and Figure 2, connect each wire to the control;
6. Fasten the multifunction control on the electrical junction box, then fasten the Decora wall plate;
7. Connect the power cable of the air exchange system and verify the proper operation of the system.
Not used
Air exchange system, green
Air exchange system, red
Air exchange system, COM
Air exchange system, 24VAC
Digital Multifunction Wall Control
Figure 1
5
4
3
2
1
Figure 2
Installation guide
611242-FC - Installation - R6