ACOPOWER HY-PTK-100Exp 매뉴얼 - 페이지 4

{카테고리_이름} ACOPOWER HY-PTK-100Exp에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ACOPOWER HY-PTK-100Exp 5 페이지.
ACOPOWER HY-PTK-100Exp에 대해서도 마찬가지입니다: 사용자 설명서 (5 페이지)

페이지 인쇄

What are you going to use it for

1. Charge solar generators

1.1. Charge 12V Solar Generator with built-in Charge Controller

Step 1: understand your solar generator and prepare the MC4 adapter for your solar generator

Step 2: Disconnect MC4 Connectors and let it to be a solar panel with MC4 connectors

Step 3: Use your MC4 Adapter to charge your solar generator

2. Charge your 12 Volt battery

The solar panel kit is designed to charge a large range of batteries including Sealed, Flooded, GEL, AGM, Lithium,

lead-acid battery and other deep cycle battery. The batteries are used as car battery, RV battery, boat battery and

emergency back-up battery.

Step 1: understand your battery: battery type, capacity and voltage

Step 2: check the charge controller's set up. We have defaulted the setting of the charge controller is for SEALED.

(AGM is also included in SEALED type.) If your battery's type is different, please set your battery type with the

charge controller following the instructions below.

3. Connect in parallel with another solar panel to charge a 12V battery faster

When you combine two solar panels in parallel, the current from the two solar panels are added together and this will

enable the battery to charge faster. For more information about adapters needed, please contact us.

Warning: Make sure the combined current is lower than the rated current of the charge

controller which is 10 amps for this model.

www.ACOPower.com

Battery

Lead-acid Battery

HY-PTK-100Exp

Lithium

Power Your Green Life!

4120 Valley Blvd Walnut, CA 91789, USA

+1-626-737 1140