Caliber RMD 571 사용자 설명서 - 페이지 15

{카테고리_이름} Caliber RMD 571에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Caliber RMD 571 17 페이지.
Caliber RMD 571에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (8 페이지)

5. Trouble Shooting

Please read the user manual carefully before using the this player. If you have any troubles

in using this player, try to solve the problems by the suggestions mentioned below. If you can

not remove the trouble after using all the suggestions, please contact the company or the

technical service centre authorized by us. For the sake of your safety, please do not open the

cover and repair the player by yourself, if that, it may cause electric shock.

NO PICTURE, SOUND AND INDICATION

* Ensure that the power switch is on.

* Ensure that the inlet is ok.

* Ensure that the power cord is not damaged or the fuse is not blown.

* Ensure that the power plug is connected to the inlet tightly.

NO SOUND BUT HAVE PICTURE

* Ensure that the player's audio output has a good connection with monitor's audio input.

* Check whether the audio connector is damaged.

* Check whether you have turned down the volume.

* Ensure that you have set the right AUDIO setup of the player.

* Ensure that the audio is not under mute.

NO PICTURE BUT HAVE SOUND

* Ensure that the player's video output has a good connection with monitor's video input.

* Check whether the video connector is damaged.

* Ensure that you have set the right VIDEO settings of the player.

BLACK AND WHITE PICTURE OR SCREEN ROLLING

* Ensure that you have set the right video SYSTEM setting.

FLAWS OF PICTURE OR SOUND

* Check whether the setting of AUDIO is right.

* Check whether the AV connector and the output terminal is stained.

* Check whether there is condensation inside the Lens. If so, leave the player off for an hour

or so, then try again.

REMOTE CONTROL IS INSENSITIVE OR DOES NOT WORK

* Check the batteries of remote control and make sure that they are to be powerful and

good conductivity.

* Direct the remote control to the IR sensor of the player.

* Check whether there are some obstacles between the remote control and IR sensor.

SOME FUNCTION BUTTONS DO NOT WORK

* Turn off the power, then turn on again.

* Reset the unit to zero, then turn on again.

* Remove the front panel from the unit, then install it again and then turn on again.

THE RADIO DOES NOT WORK

* Check whether the antenna cable is connected firmly. Or manually tune for a station.