Caliber 13576 조립 지침 매뉴얼 - 페이지 7

{카테고리_이름} Caliber 13576에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Caliber 13576 8 페이지. Sled wheels
Caliber 13576에 대해서도 마찬가지입니다: 조립 지침 매뉴얼 (10 페이지)

5. Grab one Sled Wheel assembly by the handle, hold it vertically, and slide the fingers under the ski until the wheel

axle is in line with the spindle axle. You may need to lift the ski loop to create space under the ski. Rotate the

assembly down to raise the ski and check the length of the telescoping handle. Adjust as necessary to keep the

Sled Wheels axle and the spindle axle in line.

6. When the handle and saddle are in place,

and the Sled Wheels assembly is

installed onto the ski, the latch should

swing open and close around the ski

loop. Slide the latch up until it just

touches the ski loop and tighten the

screw. Do not over-tighten.

7. Fine adjustment: If the ski tips forward or backward, Sled Wheels need slight adjustments. If the ski tips

forward, the Sled Wheels axle is behind the ski spindle axle. Shorten the telescoping handle until the two axles

line up. Conversely, if the ski tips backwards, lengthen the telescoping handle. Also, check your ski bushings;

they should be tight and not worn. Good bushings will help your ride and help keep your ski horizontal when

riding with Sled Wheels.

8. Adjust the second assembly to the same locations as the first.

- Page 7 -

CI05067, rev B