Directed Xpresskit DBALL2 설치 매뉴얼 - 페이지 3

{카테고리_이름} Directed Xpresskit DBALL2에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed Xpresskit DBALL2 13 페이지. Ford5 remote start ready (rsr) installation
Directed Xpresskit DBALL2에 대해서도 마찬가지입니다: 설치 매뉴얼 (12 페이지), 설치 매뉴얼 (19 페이지), 설치 매뉴얼 (18 페이지), 매뉴얼 (14 페이지), 설치 매뉴얼 (14 페이지), 설치 매뉴얼 (19 페이지), 설치 매뉴얼 (16 페이지), 설치 매뉴얼 (20 페이지), 설치 매뉴얼 (15 페이지), 설치 및 빠른 참조 매뉴얼 (16 페이지), 설치 매뉴얼 (18 페이지), 설치 매뉴얼 (16 페이지), 설치 매뉴얼 (18 페이지), 설치 매뉴얼 (16 페이지), 매뉴얼 (19 페이지), 설치 매뉴얼 (11 페이지), 설치 매뉴얼 (10 페이지)

페이지 인쇄

Platform: DBALL2

Firmware: CHRYSLER6

Installation without T-Harness

Note: The BCM is located in the driver side dash, above the kick panel.

Diagnostic Connector

CAN IHS High: Gray, pin 3

[2]

CAN IHS Low

[2]

White, pin 11

CAN C Low:

Yellow, pin 14

(-) Ground

Immo. Data:

White/Lt Green: pin 5

(+) 5V Ignition:

Violet/Brown,

pin 4

Ignition Node

(black connector)

Not required in D2D mode.

Tach wire is an optional connection required on some remote starters, which do not support a tach signal in D2D.

[1]

DBALL2 Only. Required for heated seats.

[2]

With the exception of the OBDII Diagnostic connector, all adapters are displayed from the wire side (unless specified otherwise).

(-) E-Brake Status Input

OBDII

CAN C High: Gray/White, pin 6

HS CAN High: Tan/Black: 3

HS CAN Low: Tan: 4

HS CAN2 High: Orange/Green: 5

[2]

HS CAN2 Low: Orange/Brown: 6

[2]

Immo. Data (conn. side): Yellow: 8

Immo. Data (veh.side): Orange/Yellow: 9

Ignition Status Output: Yellow/Red: 11

(+) 12V: Brown/Red: 12

(+) 12V: Red: 13

(+) 12V

(-) Ground: Black: 14

(-) E-Brake Output: Black/White: 1

(-) Door Status Output: Green/White: 3

(-) Trunk Status Output: Red/Black: 4

(-) (AC) Tach Output: Violet/White: 5

[1]

(+) Brake Output: Gray: 6

(+) Ignition Output: Gray/Black: 7

(MUX) Parking Light Output: Violet/Brown: 9

Immo. Data (veh.side): Yellow/Black: 10

(-) RAP Off: Orange/Black: 11

(-) Hood Status Output: Blue/Red: 12

BCM

(Blue Connector G)

(-) Hood Input

(+) Brake Input

(AC) Tach Input

[1]

(-) Trunk Status Input

(-) Door Status Input

(+) Ignition Input

Prog.Button

DBALL2

LED

Parking Lights Input: White/Brown, pin 20

(-) Driver Door Trigger: Violet, pin 9

Rev.: 20151029

(+) 12V: Red, pin 3

BCM

(+) 12 V

(Connector B)

(-) Lock Output

(-) Unlock Output

(+) Parking Light Output

(+) Starter Output

(-) GWR (Status)

10: Blue/White: (-) GWR (Status) Input

9: Pink: (+) Ignition Input

8: Violet: (+) Starter Input

7: Pink/White: (+) Parking Light Input

2: Blue: (-) Unlock Input

1: Green: (-) Lock Input

(+)12V

(-) Ground

P#: XKD2D65

BCM

(White Connector F)

Page 3

(-) Ground