Clarke 3110463 운영 및 유지 관리 지침 - 페이지 8

{카테고리_이름} Clarke 3110463에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 3110463 17 페이지. Air nibbler

OPERATION

In order to improve access to the workpiece, the die can be rotated through

360

1. To do this, loosen the locknut with

a 22mm spanner and rotate the

die on the punch until it is in the

right position for the job in hand.

2. Hold the die steady with a 15mm

spanner on its flats and retighten

the locknut.

3. Ensure you workpiece is properly

secured and marked out.

4. Connect the nibbler to the airline.

5. Start the nibbler by squeezing the throttle lever.

6. Introduce the sheet metal into the slot in the end of the die. Apply only light

pressure to move the tool in the desired direction through the material.

7. Do not allow the nibbler to run freely for long periods of time as this could

harm the bearings.

NOTE: It is recommended that a whip hose with a swivel (not included)

be used to prevent twisting, kinking and resultant wear to the air

hose.

Do not disconnect the air supply hose until the compressor has been shut

down and the compressed air released.

1. Refer to the compressor instruction manual for the procedure to shut down

and release the compressed air.

2. Once the pressure has been released, disconnect the air supply hose from

the air tool.

3. Store the tool safely in its box in a dry, secure environment.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]