Directed 1475 사용자 설명서 - 페이지 8

{카테고리_이름} Directed 1475에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed 1475 12 페이지. 4­ button automatic / manual transmission remote starter

Directed 1475 사용자 설명서
The system will warn you if someone attempts to remote start the vehicle while in Valet Mode:
The parking lights will:
Turn ON then OFF; then
Flash twice.
Panic Mode 
Note: Panic mode can only be activated if the horn has been adequately configured by the
installer.
In an emergency situation, you can activate panic mode by pressing and holding the
button for more than 3 seconds, until the horn starts honking. If the vehicle is under a remote start,
the engine will shutdown automatically before setting off the horn. You can stop the horn by
pressing:
(this will lock your doors and deactivate panic mode), or
(this will unlock your doors and deactivate panic mode).
Furthermore, the panic mode can be stopped by activating Valet Mode (page- 7)
* Panic Mode will automatically shut down after 30 sec.
Quick Lockout
(Also called Secure Panic.) For fast protection in emergency situations, the system will LOCK all
doors when you press the brake pedal while you hear the sound signal. (Quick Lockout is only
available when panic mode has been set off.)
Cold Weather Mode 
If the vehicle has a manual transmission, Ready mode (page-4) should be set before entering
Cold Weather mode. When Cold Weather Mode is active, the engine starts every 2 hours and runs
for 3 minutes (or for 8 or 20 minutes with diesel engines). Cold Weather Mode automatically ends
after 24 hours (or 12 starts).
To enter Cold Weather Mode:
Press and hold the
The parking lights will flash for 2 seconds, pause, then flash three (3) times.
To exit Cold Weather Mode, do any one of the following actions:
Open the hood.
Start the engine by remote.
Turn the ignition key to the IGNITION ON (RUN) position.
Press and hold the
then flash once.
To verify whether the system is in Cold Weather Mode (automatic transmissions only):
Press the brake pedal:
If the vehicle is in cold weather mode, the parking lights will remain ON while the brake pedal is
pressed.
Disable/Enable LED flashing 
To disable the LED:
To Enable the LED:
P. 8
 
TM
button for at least 3 seconds
button until the parking lights come ON for 2 seconds, pause,
Press
times.
Press
and
simultaneously until the parking lights flash three
and
simultaneously until the parking lights flash once.
or
User Guide