ALDI FERREX 704518 사용자 설명서 - 페이지 14

{카테고리_이름} ALDI FERREX 704518에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ALDI FERREX 704518 20 페이지. 1010w

1010W Belt Sander

Any movement of the material may affect the quality of the sanding finish.

Start your sander before sanding and turn off only after stopping.

For best results sand wood in the direction of the grain.

Do not start sanding without the sanding belt (11) fitted.

Empty the dust collection bag (12) every 5 minutes or sooner to ensure

efficient dust collection.

Maintenance

Replacing the drive belt

WARNING! Ensure the product is disconnected from the mains

power supply before attempting any maintenance tasks.

WARNING! Wear protective gloves when replacing the drive

belt.

1) Remove the screws (a) from the belt cover (7) using a Phillips screwdriver

(not supplied) by turning it anti-clockwise. And then remove the belt cover (7)

(Fig. G1, G2).

2) Carefully cut the old drive belt if it is not broken and remove it from the

belt sander.

3) Fit the new drive belt (b) around the large pulley (d) first.

4) Then install onto the small pulley (c) by rotating clockwise and pushing

the drive belt (b) shown around the small pulley at the same time. The drive

belt (b) will be a tight fit (Fig. G3).

5) Fit the belt cover (7) and then screws (a) by turning them clockwise using

a Phillips screwdriver (not supplied).

MODEL No.: PBS101.A • 02/2021 • 704518

AFTER SALES SUPPORT

1300 889 028

(toll free)