Clarke 3120163 운영 및 유지 관리 지침 - 페이지 6

{카테고리_이름} Clarke 3120163에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 3120163 9 페이지. Extra-long air blowgun

MAINTENANCE

WARNING: MAKE SURE THAT THE BLOW GUN IS DISCONNECTED FROM THE

AIR SUPPLY BEFORE STARTING ANY CLEANING OR MAINTENANCE

PROCEDURES.

1. Before use, drain water from the airline filter and compressor.

2. Clean thoroughly after use with a suitable solvent.

PERFORMANCE

Please note that factors other than the tool may effect its operation and

efficiency such as reduced compressor output, excessive drain on the airline,

moisture or restrictions in the air-line, or the use of connectors of improper size

or poor condition which will reduce air supply.

Your Clarke air tool has been designed to give long and trouble free service. If,

however, having followed the instructions in this booklet carefully, you

encounter problems, take the unit to your local Clarke dealer.

1. Shut down the air compressor (referring to the compressor instruction

manual if required).

2. Vent the compressed air remaining in the tool by squeezing the trigger.

3. Once the pressure has been released, disconnect the air supply hose from

the air tool.

ACCESSORIES

A wide range of accessories is available including filter/regulators, lubricators,

high-pressure hoses (5 to 50 metres) etc.

Contact your Clarke dealer for further information or the Clarke International

Service Department.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]