Clarke 3400771 사용자 지침 - 페이지 9

{카테고리_이름} Clarke 3400771에 대한 사용자 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 3400771 17 페이지. Plastic stapler/welder kit

OPERATION

1. Push fit the welding tip onto the heating elements.

2. Plug into the power supply and press the POWER button. Ensure the yellow

PWR and a single blue LED status indicator are on.

3. According to the shape of the

damage to be repaired, select

the corresponding staple from the

selection on page 12 and insert

into the welding tips of the

device.

4. If the plastic to be repaired has a

long crack which is likely to

extend over time, drill a small hole

at the end of the crack to prevent

this happening before beginning

the stapled repair.

5. Press the 'Grade' button to select the desired heating level (Low, Medium

or High) according to the type and thickness of plastic being welded.

6. Use the LED lamp if required by pressing the "Light" button.

7. Holding the device handle, align the staple with the crack to be repaired

and squeeze the trigger.

• The green "working" LED will light up. (A red LED shows a fault or

open circuit).

• The staple will be heated up and melt into the plastic within a few

seconds.

8. Begin working at the beginning of any long crack or split and add more

staples, progressing outward.

9. Position the device so that the

transverse part of the staple sinks

into the plastic to be repaired until

completely covered.

• Take care not to push the

staple in too far, so as to risk

breaking through the whole

thickness of the plastic

component.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]