Clarke 4500633 운영 및 유지 관리 지침 - 페이지 10

{카테고리_이름} Clarke 4500633에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 4500633 17 페이지.

nut will be impacted repeatedly until it is loosened. IMPORTANT! Release

the trigger immediately the nut begins to loosen.

3. Jack up the vehicle according to the vehicle handbook so that the wheel

is clear of the ground, then proceed to fully undo the wheel nuts.

WARNING: ENSURE THAT THE CORRECT SOCKET IS BEING USED FOR THE

NUTS ON YOUR PARTICULAR VEHICLE. AN INCORRECT SOCKET SIZE IS

LIKELY TO DAMAGE THE HEADS OF THE BOLTS/NUTS.

TIGHTENING A NUT

1. Start the nut by hand, ensuring it is not cross threaded, then with the

appropriate socket installed on the wrench, place it on the nut.

2. With the FORWARD/NEUTRAL/REVERSE switch-bar in the clockwise

(FORWARD) running position, and holding the wrench firmly in BOTH

HANDS, pull the trigger.

3. Run each nut up in turn until it is 'nipped' up only - do not tighten. When all

nuts are nipped up, tighten progressively by pulling the trigger fully and

allowing the action to operate for 3 to 4 impacts only to prevent

overtightening.

4. ALWAYS finish tightening with a torque wrench. The weight of the vehicle

will need to be placed on the wheel to prevent it from rotating while the

nuts are tightened. Ensure the final torque applied to the nuts meets the

vehicle manufacturer's recommendations.

RECHARGING

Recharge the battery pack following each period of use as described on

pages 7-8.

1. Check that the red CHARGING light illuminates and remains on during the

charging process.

2. If the red CHARGING light goes out almost straight away after repeating

this procedure a couple of times, although the green POWER ON light is lit,

the battery pack should be replaced with a new one.

3. The charging light should remain on for about 1 hour, after which, the

battery cartridge may be removed and used.

4. After charging, remove the charger from the power supply.

5. For maximum battery life, we recommend that you maintain the battery in

a fully charged state at all times.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]