Clarke 6462000 운영 및 유지보수 지침 매뉴얼 - 페이지 13

{카테고리_이름} Clarke 6462000에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 6462000 17 페이지. Rotary tool set

CLEANING AND MAINTENANCE

WARNING: MAKE SURE THAT THE TOOL HAS BEEN DISCONNECTED FROM

THE POWER SUPPLY BEFORE REMOVING OR FITTING A COLLET OR

ACCESSORY

1. ALWAYS unplug the tool from the mains supply and ensure it is switched OFF

when performing maintenance tasks.

2. The tool should be kept clean at all times. Ensure the ventilation ducts are

clear and the power cable is in good condition. Get into the habit of

cleaning thoroughly after each use and before storing.

3. After use, thoroughly clean all chippings and dust from the rotary tool,

taking special care to clean the cooling vents.

4. Never clean with solvents. Use a moist cloth with soapy water if necessary.

5. Clean the spindle lock, the chuck and the spindle collar.

6. Keep all accessories sharp and clean.

The tool incorporates sealed for life bearings and does not require lubrication.

There are no user serviceable parts inside this tool.

Worn or damaged parts should be replaced by qualified personnel.

Refer to qualified service personnel if internal maintenance is required.

ACCESSORIES

Accessory Kits are available from your dealer. Please quote part number

6468025 (CRT100A - 100 piece) or part no 6462001 (CRT40 - 40 piece kit).

By purchasing this product, the customer is taking on the obligation to

deal with its safe disposal in accordance with the Waste Electrical and

Electronic Equipment (WEEE).

This product must not be disposed of with general household waste but be

disposed of according to the laws governing Waste Electrical and Electronic

Equipment (WEEE) at a recognised disposal facility.

This product contains valuable raw materials. Metal products should be taken

to your local civic amenity site for recycling.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]