Clarke 6462180 운영 및 유지보수 지침 매뉴얼 - 페이지 9

{카테고리_이름} Clarke 6462180에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 6462180 17 페이지.

5. To start the jigsaw, squeeze the

trigger. Wait until the blade is

running at speed before

attempting to cut the workpiece.

6. Maintain the saw at constant

speed by pressing in the lock-on

button.

• You can then release your

finger pressure on the trigger.

7. To stop the jigsaw if the lock-on

button is used, squeeze the trigger fully in, then release it and the motor will

stop.

USING THE JIGSAW

1. Place the sole-plate on the workpiece and squeeze the trigger to run the

jigsaw up to its working speed before letting the blade touch the cut line.

To make your cut, move the saw slowly forward along the cutting line.

2. Adjust the speed controller to suit the material being cut using the following

suggested settings as a starting point. However, the optimum speed will be

determined with practice.

• Plastic

• Steel

• Hardboard

• Ceramic, aluminium, non-ferrous metals

• Timber, plywood & chipboard

3. Take extra care when cutting curves - move the blade slowly to avoid stress

on the blade.

4. When sawing, hold the jigsaw in front of you but do not put unnecessary

pressure on the blade and avoid applying lateral pressure.

5. Let the blade work through the workpiece, ensuring the sole plate is flush

with the workpiece.

ADJUSTING THE PENDULUM

The pendulum moves the blade away from the cut on the down (non-cutting)

stroke. The pendulum can be particularly useful when cutting thicker, denser

materials.

1. Adjust the control to suit the material being worked, and try to balance its

use with adjustments to the speed of the saw to achieve the optimum

setting for the job.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]

1 - 3

2 - 4

3-4

3-6

4-6