Clarke 6480237 운영 및 유지보수 지침 매뉴얼 - 페이지 11

{카테고리_이름} Clarke 6480237에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 6480237 17 페이지. Metalworker multi purpose sharpener

3. Take care that the sharpening

angle matches the existing

bevelled angle of the blade tip.

This avoids removing too much

metal unnecessarily and keeps

the plane blade at its optimum

cutting angle.

4. Adjust it to suit and set the angle

securely using the adjusting knob.

Note the angle on the scale

before tightening.

5. Switch the power unit on.

6. Slide the blade and plate with

light, steady pressure, back and

forth across the grinding wheel in

a continuous motion.

• Do not hold the blade

stationary as this will cause irregular sharpening.

7. Gradually ease the blade down the plate while sharpening. Press very

gently, repeating each step.

8. Lift the blade away and check that the bevelled edge and tip are evenly

sharp across the blade width. If not, adjust the grinding angle and try

again.

9. Use the extra side guide to act as

a spacer when sharpening narrow

chisels.

10. Switch the power unit off and

ensure the grinding wheel has

stopped before removing the

sharpener attachment from the

base unit.

• It is recommended that after

grinding, the chisel or plane

blade tip is honed using an oiled stone.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]