Clarke 6480237 운영 및 유지보수 지침 매뉴얼 - 페이지 6

{카테고리_이름} Clarke 6480237에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 6480237 17 페이지. Metalworker multi purpose sharpener

SETTING UP THE SHARPENER

This sharpener should only be used on a stable, horizontal surface. It is

intended to be screwed down onto a workbench using the mounting holes in

the base. Use 4 x 1" No 8 counter-sunk screws (not supplied).

The sharpener is fitted with an interlock which prevents the motor from starting

unless one of the sharpening attachments is clipped into its operating position

on the power unit.

To attach each sharpening

attachment, slide it fully down the

slots on the front of the power unit

until it latches into place.

To release any sharpening

attachment, unclip it by pressing the

release catch down. Always wait for

the grinding wheel to stop before

removing the attachment. Store all

the attachments on sides of the

power unit when not in use.

Plug the sharpener into a suitable mains power outlet.

Using this attachment, you can sharpen any high speed drill bits from 7/64"

(3mm) to 3/8"(10mm). The sharpener holds the drill bit at the correct

sharpening angle.

Do not use with masonry or hammer drill bits.

1. Slide the drill sharpening

attachment onto the front of the

power unit and clip into place.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]