Clarke 7640125 운영 및 유지보수 지침 매뉴얼 - 페이지 5

{카테고리_이름} Clarke 7640125에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 7640125 8 페이지. Portable sandblaster hopper kit

OPERATION

USING YOUR SANDBLASTER

The compressor used must be at least 3hp and capable of supplying a

minimum of 10 CFM of air

Connect an air hose (sold

separately) from your compressor,

to the hose fitting on the

sandblasting gun. Fig 1.

• Set the air pressure on your air

compressor to 100 -150 psi.

Make sure air hole located on the

base of the hopper is not

covered. Fig 2.

3. Pour the blasting medium into the

hopper.

4. Start compressor according to the

manufacturers instructions.

5. Check for leaks along all hoses

and fittings. if leaks are found, turn

off the compressor, disconnect

the hose and repair immediately.

6. Point the sandblasting gun in a safe direction away from people, pets or

anything around you that may be damaged by direct or indirect abrasive

spray.

7. Press and hold the sandblasting gun trigger until abrasive medium is flowing

through the nozzle.

TO STOP BLASTING

1. Release the trigger on the sandblasting gun.

FIG 1

FIG 2