Clarke 7640130 운영 및 유지보수 지침 매뉴얼 - 페이지 10

{카테고리_이름} Clarke 7640130에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 7640130 20 페이지. Pressurised sandblaster

TO START BLASTING

NOTE: Start with all valves in the closed position. Following the instructions

below will help prevent clogging in the delivery hose, outlet

manifold and the safety trigger.

1. Connect compressor to the inlet connector.

Start compressor and open the air

supply valve, see Fig 9.

• The tank will start to pressurise.

Test the safety valve by pulling up

on the valve as shown in Fig 10.

• Air will hiss out when the valve is

pulled.

Open the throttle valve, Fig 11.

5. Check for leaks at the filler cap

and along all hoses and fittings as

the system pressurises. If leaks are

observed, release the pressure

from the tank and repair leaks

immediately.

6. Press and hold the safety trigger

until air is flowing through it.

With the safety trigger open,

slowly open the abrasive control

valve and shown in Fig 12 until

abrasive material begins to flow

out of the safety trigger.

8. Adjust the abrasive control valve

until the desired amount of

abrasive material is flowing

through the safety trigger,

9. Begin blasting.

Fig 9

Fig 10

Fig 11

Fig 12