Clarke 7640134 운영 및 유지보수 지침 매뉴얼 - 페이지 5

{카테고리_이름} Clarke 7640134에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 7640134 17 페이지. Pressurised sandblaster

ASSEMBLY

FIT THE PRESSURE GAUGE TO THE TANK

1. Screw the pressure gauge onto

the sandblaster as shown in Fig 1.

1. Lay the tank on a flat level surface

such as a workbench, with the

handlebar mounting brackets

facing up, as shown in Fig 2.

2. Align the holes in the left

handlebar with the handlebar

mounting brackets on the left side

of the tank.

3. Fit a washer to each of the

handlebar mounting screws. Insert

a screw through each hole in the handlebar and mounting brackets.

4. Fit a nut onto each of the screws and firmly tighten with a wrench.

5. Repeat steps 2-4 for the right handlebar.

1. Slide the axle through the holes at

the bottom of the handlebars, see

Fig 3.

2. Slide a washer onto each end of

the axle.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]

Fig 3

Fig 1

Fig 2