Clarke CAT108 (1/2) 운영 및 유지보수 지침 매뉴얼 - 페이지 6

{카테고리_이름} Clarke CAT108 (1/2)에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CAT108 (1/2) 16 페이지. Reversible ratchets 1/2" and 3/8"

• If an unusually long air hose is required, (over 8 metres), line presure may

need to be increased.

A typical airline layout is

shown on the right. If an

automatic in-line filter/

regulator/lubricator unit

is used it will keep the

tool in good condition,

but should be regularly

checked and topped

up with oil.

IMPORTANT: If a filter/

lubricator unit is not used, the tool should be lubricated with 2 to 6 drops of oil,

at least once a day or after 2 hours work, depending upon the working

environment. The oil can be inserted through the airline connection point.

AIRLINE SAFETY

• Never exceed the maximum operating pressure for the tool. A pressure of

90psi with a flow of 4 cfm is required. Too high an air pressure will shorten

the life of the tool due to excessive wear.

• The air hose must be rated at least 150% of the maximum operating

pressure of the tool.

ASSEMBLY

1. Remove the plastic blanking plug from the connection port of the tool as

shown in Fig 1.

2. Pour 2-3 drops of CLARKE airline oil into

the air inlet. This should be done

regardless of whether or not a

lubricated air supply is to be used.

3. Connect a suitable hose to the tool as

shown. Use the screw-in adapter

supplied if required.

4. Connect the other end of the hose to

the compressor.

(A whip hose with a quick fit coupling is

available from your CLARKE dealer).

5. Turn on the air supply and check for air

leaks. Rectify any found before

proceding.

The tool is now ready for use.

Fig 1