Clarke CAT109 (3/8) 운영 및 유지보수 지침 매뉴얼 - 페이지 7

{카테고리_이름} Clarke CAT109 (3/8)에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CAT109 (3/8) 16 페이지. Reversible ratchets 1/2" and 3/8"

OPERATING INSTRUCTIONS

IMPORTANT: Only use sockets designed for use with a ratchet wrench;- either

3/8" (10mm) for the CAT109 or 1/

2" (13mm) for the CAT108.

1 Select the socket you require.

2. Press the socket until it clicks into

place on the square drive.

3. Place the socket over the subject

nut.

• Take care that the socket is firmly

engaged on the nut to be

tightened or removed.

4. Squeeze the trigger against the

body of the tool to start as in Fig

5. Release the trigger to stop the

tool.

6. Always ensure the tool has

stopped before putting it down.

7. To change the direction, twist the

control at the tip of the tool to

either 'F' for forward or 'R' for

reverse as in Fig 3.

DISCONNECTING THE AIR SUPPLY

1. Do not disconnect the air supply hose until the compressor has been shut

down and the compressed air pressure released.

2. Once the pressure has been released, disconnect the air supply hose from

the tool.

STORAGE

1. Store the tool safely in its box in a dry, secure environment.

2. If the tool is not to be used for longer than 24 hours, run a few drops of

CLARKE airline oil into the air inlet and run the tool for a few seconds to

ensure that the oil has been well distributed throughout the tool.

3. When storing, ensure the blanking plug is replaced on the airline

connector once the airline has been disconnected.

Fig 2

Fig 3