Clarke CAT141 운영 및 유지 관리 지침 - 페이지 10

{카테고리_이름} Clarke CAT141에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CAT141 17 페이지. Air impact wrench
Clarke CAT141에 대해서도 마찬가지입니다: 운영 및 유지 관리 지침 (17 페이지)

페이지 인쇄

MAINTENANCE

WARNING: MAKE SURE THAT THE AIR TOOL IS DISCONNECTED FROM THE

AIR SUPPLY BEFORE STARTING ANY CLEANING, OR MAINTENANCE

PROCEDURES.

DAILY

1. Before use, drain water from the airline filter and compressor.

2. Pour a few drops of Clarke air-line oil, into the tool air inlet. This should be

carried out regardless of whether or not an in-line mini oiler is used. If an in-

line mini oiler is not used, this procedure should be repeated after every

two to three hours of use.

3. Keep the body of the tool clean and free from debris.

WEEKLY

• Check the air inlet screen filter

for blockage and clean if

necessary.

CLEANING

1. Grit or gum deposits in the tool

may reduce efficiency and cause

the tool to run erratically. This

condition can be corrected by

cleaning the air strainer and

flushing out the tool with gum

solvent or oil.

2. Failing this, the tool should be disassembled, thoroughly cleaned, dried

and reassembled.

3. The tool may be dismantled by removing the front cover using the hex key

supplied prior to replacing any worn or damaged parts. You may prefer to

take the tool to your Clarke dealer if internal maintenance is required.

4. While in a dismantled state, it may be desirable to grease the hammer

mechanism and applying a small amount of good quality bearing grease.

• This may be better left to your Clarke dealer.

• A hex key is provided for removing the end cover from the wrench.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]