Clarke CAT211 운영 및 유지 관리 지침 - 페이지 2

{카테고리_이름} Clarke CAT211에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CAT211 8 페이지. 3pc air blow gun kit

INTRODUCTION

Thank you for purchasing this CLARKE Blow Gun kit.

Before attempting to use this product, please read this manual thoroughly and

follow the instructions carefully. In doing so you will ensure the safety of yourself

and that of others around you, and you can look forward to your purchase

giving you long and satisfactory service.

Please keep these instructions in a safe place for future reference.

SPECIFICATION

Max Operating Pressure

Air Inlet Size

Air Consumption

Dimensions

WARNING: COMPRESSED AIR CAN BE DANGEROUS. ENSURE THAT YOU

ARE FAMILIAR WITH ALL PRECAUTIONS RELATING TO THE USE OF

COMPRESSORS AND COMPRESSED AIR SUPPLY.

Use only clean, dry, regulated compressed air as a power source.

A build-up of moisture or oil in the air compressor will accelerate wear and

corrosion in the tool. Ensure any moisture is drained from the compressor daily

and the inlet filter is kept clean.

If an unusually long air hose is required, (over 8 metres), the line pressure or the

hose inside diameter may need to be increased.

The hose must be rated at 150% of the max operating pressure of the tool.

If an automatic in-line filter/regulator is used, it will keep the tool in good

condition, but should be regularly checked.

Never exceed the maximum operating pressure for the air tool. It is

recommended that air pressure to this tool does not exceed 90 psi. Higher

pressures and dirty air will shorten the life of the tool due to faster wear and is a

possible safety hazard

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]

90 psi (6.2 bar)

1/4"BSP Female

9.5 cfm (max @90psi)

Pocket Blow Gun - 97 x 20 x 29mm (0.057kg)

Short nozzle Blow Gun - 130 x 140 x 21mm (0.13kg)

Long nozzle Blow Gun - 240 x 17 x 87mm (0.085kg)