Clarke CEW1000 운영 및 유지보수 지침 매뉴얼 - 페이지 10

{카테고리_이름} Clarke CEW1000에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CEW1000 20 페이지. Electric impact wrench

MAINTENANCE

CLEANING

• Always inspect the tool before use, and ensure it is in top condition.

• Ensure all air vents are clear, (use compressed air to clean the

machine if possible).

GENERAL MAINTENANCE

• Ensure all nuts, bolts and screws remain tight to ensure the machine

is in safe working condition.

• Refer to your CLARKE dealer if internal maintenance is required.

• Check the power cable to ensure it is sound and free from cracks,

bare wires etc. avoid using solvents when cleaning plastic parts,

most plastics are susceptible to damage from the various types of

commercial solvents.

• All bearings etc, in this tool are lubricated with a sufficient amount

of high grade lubricant for the tools lifetime under normal operat-

ing conditions, therefore no further lubrication is required.

REPLACING THE CARBON BRUSHES

Remove and inspect the carbon

brushes after periods of extended use.

Replace them when they eventually

wear down. The brushes should be kept

clean and free to slide up and down in

the holders. Both brushes should be

replaced at the same time as a pair.

Only use identical brushes from your

Clarke dealer.

Use a screwdriver to remove the brush

holder covers from the machine body.

Draw out the worn brushes and insert

new ones before replacing the brush

holder caps.