Clarke CMFT300QR 운영 및 유지보수 지침 매뉴얼 - 페이지 12

{카테고리_이름} Clarke CMFT300QR에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CMFT300QR 17 페이지. Multi function tool with quick release

USING THE SCRAPER

The scraper is used to remove residues (paint, sealant, adhesives), and vinyl/

fabrics from a workpiece.

1. Fit the scraper as shown on page

8. Hold the tool tightly and move

the On/Off switch forward.

2. Put the tool against the

workpiece, at a low angle and

apply light pressure to the scraper

blade.

• Let the tool to do the work and

do not apply excessive

pressure, which can cut into

the surface and overload the tool.

NOTE: The scraping blade is designed for scraping soft materials from flat

surfaces.

NOTE: The scraper blade is sharp and can dig into the surface of soft

materials such as timber in the same way as a chisel.

USING THE SAW ATTACHMENT

The saw attachment is used to cut materials such as wood, plastics and sheet

metal such as aluminium.

CAUTION: CLAMP THE WORKPIECE SECURELY IF POSSIBLE BEFORE

STARTING WORK.

CAUTION: ALWAYS CHECK THAT THERE ARE NO NAILS OR SCREWS IN THE

WORKPIECE BEFORE CUTTING.

NOTE: Ensure the blade is sharp and not damaged before starting work.

SAWING WITH THE STRAIGHT BLADE

1. HFit the scraper as shown on

page 8. Hold the tool tightly and

move the On/Off switch forward.

2. If making a plunge cut use a slight

pendulum motion to allow chip/

debris removal.

NOTE: Plunge cuts should only be

attempted on soft materials

such as softwood and

plaster boards.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]