Clarke CONTRACTOR CON1450WC 작동 및 유지 관리 지침 - 페이지 8

{카테고리_이름} Clarke CONTRACTOR CON1450WC에 대한 작동 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CONTRACTOR CON1450WC 17 페이지. Wall chaser

REPLACING THE CUTTING DISCS

WARNING: Disconnect the plug from the power source before making

any adjustments or changing accessories.

NOTE: Always replace both discs at the same time.

Remove the depth adjustment

knob by hand and 3 bolts

indicated using the 5mm hex key

supplied.

2. Lift off the side plate.

3. Press and hold the spindle lock

button.

4. Use the Pin Spanner supplied to

release the outer flange

SETTING THE CUTTING WIDTH

The cutting width is determined by

the number of spacer discs you put in

between the discs.

• The cutting width is equal to:

The thickness of the 2 blades (2

x 2.5 mm) + the thickness of the

spacers.

• Make sure that the inner flange

is seated properly and the flat

section has engaged with the

flat part at the base of the spindle.

NOTE: All spacers must be used to prevent the blades from wobbling.

simply place the spacers on the outside of the cutting discs to

make the cutting width narrower.

5. Replace the side plate and secure with the depth adjustment knob and 3

bolts you removed in step 1.

Side plate