Clarke CONTRACTOR CON800 운영 및 유지 관리 지침 - 페이지 7
{카테고리_이름} Clarke CONTRACTOR CON800에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CONTRACTOR CON800 17 페이지. 800w jigsaw with laser
페이지 인쇄
BEFORE USE
FITTING THE JIGSAW BLADE
WARNING!
Before removing, or installing a jigsaw blade, make sure that the
mains plug has been removed from the mains supply.
1.
Loosen the two blade securing
screws, using the hexagonal key
provided.
2.
With the blade teeth facing forwards,
push the blade shank into the blade
locating clip as far as possible.
3.
Slightly tighten the two blade
securing screws alternately, to
position the blade.
4.
Ensure that the blade is straight and resting on the blade support roller.
5.
Fully tighten the two blade securing screws.
FITTING THE PARALLEL FENCE
The parallel fence allows you to cut in a straight line, parallel to the edge of
the workpiece.
To fit and adjust the parallel fence:
1.
Loosen the parallel fence locking screws.
2.
Push the parallel fence through the
locating slots on the base plate.
3.
Set the width required and tighten
the locking screws.
4.
When cutting, ensure that the
parallel fence is resting against the
edge of the workpiece.
NOTE:
The parallel fence can be fitted to either side of the base
plate.
Blade
securing
screws
Blade
locating
clip
Fig 1
Parallel
fence
locking
screws
Parallel fence
Fig 2
7