Aldor Automotive OPE2RISU 조립 지침 - 페이지 2
{카테고리_이름} Aldor Automotive OPE2RISU에 대한 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Aldor Automotive OPE2RISU 4 페이지. Partner iii (k9) / rifter / berlingo iii (k9) / combo e roofspoiler
페이지 인쇄Partner III (K9) / Rifter / Berlingo III (K9) / Combo E roofspoiler
ATTENTION:
To obtain an optimal fixation the room temperature at mounting should be at least 15°C!
Mounting
1.
Check the fit of the spoiler on the car. Please ensure that:
both spoiler halves connect well together
both spoiler halves do not touch each other when the doors are opened.
If necessary correct the position of the doors.
2.
Apply tape to the rear doors, on the areas were the mounting holes will be drilled.
3.
In case the inserts of the spoiler are polluted by paint, clear thread by means of an M5-tap.
4.
Screw the black thread-pieces in the inserts of the spoiler, so that the pointing ends are sticking out 2 to 3 mm.
5.
Place the spoiler in de right position on the rear doors. Apply light pressure, thus enabling the black thread-
pieces to mark the drilling points on the rear doors.
6.
Remove the spoiler from the tailgate. Remove the black thread-pieces out of the spoiler.
7.
Drill the mounting holes at the marked positions. Pre-drill with 2.5 mm and then finish off with a 6 mm drill.
8.
Deburr the holes. Remove the tape and clean the tailgate with degreaser.
9.
Apply primer to the holes and allow to dry.
10. Use coarse sandpaper to remove the paint on the mounting surface of the spoiler, so that the basic material
becomes visible.
11. Clean the mounting surface of the spoiler with degreaser and apply the enclosed spoiler glue.
12. Place the spoiler on the rear doors and fasten it with the enclosed hexagonal bolts + rings.
ATTENTION:
Allow the glue to dry and do not drive the car for 12 hrs. During 24 hrs no mechanical loading should
be applied to the part. Do not wash for 48 hrs.
No warranty acceptance of any damage due to the use of a car wash.
ASSEMBLY INSTRUCTIONS
for car model with 2 rear doors
PEU4PASU-PEU2RISU-CIT4BESU-OPE2RISU-NL-ENG-D-F-D / Rev. 0
Type
: PEU4PASU / PEU2RISU
CIT4BESU / OPE2RISU
Material
: PU
Parts list
:
Part
Roofspoiler
Black pointed thread-piece
Hexagonal bolt M5x10 + ring
Tube spoilerglue
Required tools:
- tape
- tap M5
- drill 2.5 mm and 6 mm
- degreaser
- primer
- sandpaper
- hex wrench M5 (4 mm)
Van Hilststraat 4
5145 RL Waalwijk
The Netherlands
tel: +31-416-344 778
fax: +31-416-344 984
www.aldorautomotive.com
Qty
1
4
4 + 4
1