Clarke CPSB100B 운영 및 유지보수 지침 매뉴얼 - 페이지 10

{카테고리_이름} Clarke CPSB100B에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CPSB100B 17 페이지.

TO STOP BLASTING

1. While continuing to squeeze the

trigger, turn the abrasive control

valve to the closed position, see

Fig 14.

2. When you notice only air (no

abrasive material) is coming out of

the gun, you can stop the air flow

by releasing the trigger. By doing

this you are ensuring a clean

manifold, hose and gun.

3. ALWAYS clean the gun thoroughly after use.

1. When finished blasting, close the

abrasive control valve, see Fig 15.

2. Squeeze the trigger to expel any

remaining abrasive material from

the abrasive media hose and gun.

3. When you notice only air (no

abrasive material) is coming out

of the nozzle, close the Air Supply

Valve, see Fig 16.

4. Ensure the throttle valve is open,

see Fig 17.

5. Point the gun in a safe direction.

6. Squeeze the trigger until air stops

flowing and the pressure gauge

reads "0".

7. Disconnect air supply hose from

the supply valve.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]

Fig 14

Fig 15

Fig 16

Fig 17