Clarke CSB34 운영 및 유지보수 지침 매뉴얼 - 페이지 7

{카테고리_이름} Clarke CSB34에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CSB34 12 페이지. Siphon feed

OPERATION

USING YOUR SANDBLASTER

Connect your sandblasting gun to a compressor (minimum 3hp capable of

supplying a minimum of 10 CFM of air) via the 3/8" hose adaptor located at

the base of the handle.

Set the working pressure on your air compressor to 6 - 8 bar (87 - 116 psi).

1. Connect an air hose (sold

separately) from your compressor,

to the hose fitting on the

sandblasting gun.

2. Make sure air hole located on the

base of the abrasive tank is not

covered.

3. Place the mesh filter on top of the

drum and pour the blasting

medium through the filter into the

drum.

4. Start compressor according to the

manufacturers instructions.

5. Check for leaks along all hoses

and fittings. if leaks are found, turn off the compressor, disconnect the hose

and repair immediately.

6. Point the sandblasting gun in a safe direction away from people, pets or

anything around you that may be damaged by direct or indirect abrasive

spray.

7. Press and hold the sandblasting gun trigger until abrasive medium is flowing

through the nozzle.

TO STOP BLASTING

1. Release the trigger on the sandblasting gun.