Directed DBALL-GM10 XPRESSKIT 빠른 참조 매뉴얼 - 페이지 13

{카테고리_이름} Directed DBALL-GM10 XPRESSKIT에 대한 빠른 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed DBALL-GM10 XPRESSKIT 16 페이지.

Platform: DBALL

Firmware: GM10 v. 2.08+

Feature Programming

To enter feature programming routine

Turn the ignition ON, then OFF.

Within 5 seconds, press and HOLD the programming button until the LED turns ON orange (after 3 seconds). Release the

Programming button.

The LED will flash green once slowly to indicate the feature number is 1. After a short delay, the LED flashes red rapidly to indicate

the current option of feature 1 (i.e. 1x green followed by 1x red indicates feature 1 is set to option 1). The flashing sequence will

repeat until a new command is entered.

Changing feature options

Press the lock/arm or unlock/disarm button on aftermarket transmitter to change the option of the selected feature.

The LED flashes red rapidly the number of times equal to the current option number. After a short delay, the LED flashes green

slowly the number of times to indicate the current feature.

Accessing another feature

Press and release the programming button a number of times to advance from the current feature to the next desired

The LED flashes green slowly the number of times equal to the feature number. After a short delay, the LED flashes red rapidly to

indicate the current option of the current feature.

When the maximum number of features or options is reached, the LED will start flashing again from the first feature or

option.

Once a feature is programmed

Other features can be programmed.

The feature programming can be exited.

Exiting feature programming

No activity for 30 seconds; after 30 seconds, the LED will turn ON

sequence.

Press and HOLD the programming button for 3 seconds. After 3 seconds, the LED will turn ON

end of the programming sequence

The flashing sequence will repeat until a new command is entered.

orange

for 2 seconds to confirm the end of the programming

orange

Rev.: 20130304

Page 13

Programming

Button

feature

for 2 seconds to confirm

the