ALDS SOUND BUDDY S92 사용 설명서 - 페이지 3

{카테고리_이름} ALDS SOUND BUDDY S92에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ALDS SOUND BUDDY S92 4 페이지.

Pairing & using the handheld wireless microphone:

Usage instructions:

1. Turn on/off the microphone by holding down the power button on the

microphone until the power button turns blue.

2. When turning off the microphone, hold down the power button until

the blue light goes out.

Pairing the microphone to the SoundBuddy Amplifier:

1. Turn on the SoundBuddy amplifier and then long press the UHF (4)

button and the red indicator light will flash, this means the amplifier

has entered into the UHF wireless pairing status.

2. Turn on the handheld microphone; then short press the power button

three (3) times in rapid succession. This will put the microphone into

pairing mode.

3. The red indicator light on the amplifier and the blue power light on the

handheld microphone will turn solid in colour and remain solid if the

pairing was successful.

After the initial pairing, when you turn on the amplifier and microphone

next time you go to use the system, they should pair automatically.

Charging the handheld microphone:

When the blue power light turns red and starts blinking, it is time to

charge the microphone. Lift the rubber flap covering the microphone

charging port and connect the included charging cable and plug the cable

into the applicable power source. The indicator light (power button) will

flash red while the microphone is charging. Once the light stays solid red,

the microphone is fully charged and can be used again.

Do not use the microphone while it is being charged.

SoundBuddy

Amplifier Instructions:

1. Power Switch: A long press will turn on the amplifier, The light

will turn red and be on all the time. A long press again will turn off

the amplifier and the red light will go out

2. Mode key: A short press on the "M" key will switch the amplifier

modes between USB, TF card, AUX mode and Bluetooth mode

3. Play / Pause: In TF card mode, Bluetooth mode or USB mode, a

short press on the play/pause button will pause the sound track.

Press the button again to resume playback

4. UHF mode key: In "power on" status, a short press of the UHF

button will start the wireless amplification mode. A short press again

will turn off the UHF mode. A LONG press of the UHF button enacts

the pairing of a UHF transmitting device (ie microphone or body pack

transmitter) manually

5. Next / Fast forward button: In the TF card or USB mode, a short

press of the button will start the next track. A long press of the button

will fast forward through the sound tracks.