Clarke STRONG-ARM CS10BRK 운영 및 유지보수 지침 매뉴얼 - 페이지 6

{카테고리_이름} Clarke STRONG-ARM CS10BRK에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke STRONG-ARM CS10BRK 17 페이지. Body repair kit

OVERVIEW

This body repair kit is designed for bending chassis frames and repairing dents

in vehicle body panels. In most cases, the kit will only return the vehicle body

parts to approximately their original position. Additional work will be required

to complete the repair.

There are two attachments which can be connected to the pump unit.

• The Hydraulic Ram is for use in larger spaces where greater force is

needed and where there is sufficient room. It requires a solid

immovable base, directly in line with the damaged area.

• The Spreader Wedge is used in tighter spaces where the Ram and

other accessories will not fit.

THE ATTACHMENTS

Several different attachments are provided that may be used in conjunction

with the Hydraulic Ram dependant upon the nature of the damage.

• The Flat Base is used to spread the load of the Hydraulic Ram. It

should be connected to the static end of the Hydraulic Ram using

the Male Connector.

• The Rubber Head is typically used for popping dents out of sheet

metal such as doors and body panels when plugged into the

moving end of the Hydraulic Ram or the Extension Tubes.

• The Square V-Head is used to align the force of the Hydraulic Ram

when bearing against an angled frame, and may be attached to

the Hydraulic Ram or the Extension Tubes.

• The Wedge Head is used to repair small dents and areas located in

angles and tight spaces and attaches to the Hydraulic Ram or

Extension Tubes.

• The Male Connector plugs into the female end of the Hydraulic Ram.

• The Angled Toe and Plate Head are normally attached to the

extension tubes but could be used as a substitute for the flat base if

space is limited.

• The Serrated Cap is used for pushing during frame repair. It may be

plugged into either end of the Hydraulic Ram or Extension Tubes.

• The Extension Tubes plug together in different combinations to reach

the desired length.

• The Hydraulic Spreader Wedge is used in restricted spaces when the

Hydraulic Ram cannot be used. Connect the wedge directly to the

hose of the pump unit.