Clarke STRONG-ARM CS4BRK 운영 및 유지보수 지침 매뉴얼 - 페이지 9

{카테고리_이름} Clarke STRONG-ARM CS4BRK에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke STRONG-ARM CS4BRK 17 페이지. Body repair kit

5. Aim the pushing end towards the damaged area and slowly apply

pressure with the pump.

6. Once contact is established at each end, keep as well clear as practical

and slowly apply pressure to the damaged area until the desired

correction has been made.

CAUTION: KEEP HANDS AWAY FROM CONTACT AREAS AND TIGHT

SPACES IN CASE THE COMPONENTS SHOULD SLIP AND CAUSE INJURY.

7. When the damaged area has been bent to the desired position, slowly turn

the release valve on the pump unit in a counterclockwise direction to

release hydraulic pressure before removing the Ram.

USING THE SPREADER WEDGE

1. Determine in which direction the metal needs to be spread.

2. Remove any obstructions that are in the way and could be damaged.

3. Place the Spreader Wedge so that the hinged arm is resting against the

part to be moved and the stationary base is bearing against a rigid

support. Hold the Spreader Ram in position and apply the pump pressure.

4. Once contact is established at each end, keep as well clear as practical

and slowly apply pressure to the damaged area until the desired

correction has been made.

CAUTION: KEEP HANDS AWAY FROM CONTACT AREAS AND TIGHT

SPACES IN CASE THE COMPONENTS SHOULD SLIP AND CAUSE INJURY.

5. When the damaged area has been bent to the desired position, slowly turn

the release valve on the pump in a counterclockwise direction to release

hydraulic pressure before removing the wedge.