Zanussi DF47/51FF 사용 및 관리 지침 - 페이지 12
{카테고리_이름} Zanussi DF47/51FF에 대한 사용 및 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi DF47/51FF 32 페이지. Fridge freezer
Zanussi DF47/51FF에 대해서도 마찬가지입니다: 사용 및 관리 지침 매뉴얼 (32 페이지), 사용 설명서 지침 (32 페이지)
THE CONTROLS
To start the cooling system, plug into the wall
socket and switch the mains on/off switch to the
'on' position which is I. Then turn the
thermostat to setting 4-5. The temperature in the
fridge and freezer compartments will be
affected by the location, room temperature and
the number of times the door is being opened,
an adjustment of the thermostat setting may be
needed to allow for this. When operating, the
outside front edges of the freezer may feel warm
to the touch. This is quite normal.
Thermostat Control
There is one control for setting the temperature
of both the fridge and the freezer
compartments.
The thermostat dial (• -7) is located in the
control panel on the top of the appliance (See
Fig. 8). The higher the number the lower the
temperature. Normal setting is 4-5, on setting •
the cooling system is switched off but the
appliance is not disconnected from the
electricity supply. (The interior light will still
come on when the door is opened).
Green (Mains On) Indicator Light
When the appliance is switched on at the mains
and also at the mains on/off switch, the green
indicator light will illuminate and continue to do
so until the appliance is switched off.
Red Temperature Warning Light
This light will illuminate when the appliance is
first switched on and will cease to glow when
the freezer temperature falls to the required
storage level. In some circumstances (such as
after the automatic defrost period) the light may
illuminate for a short time. This is normal. If
however, the light fails to go out, please make
some checks (these can be found on 'What
Happens If Something Goes Wrong? page 23;).
Mains On/Off Switch
For the appliance to operate this switch must
be in the I position as well as being plugged
into the electricity supply.
Humidity Control Switch
This switch should be in position 'N'
(NORMAL) which ensures that no
condensation will be visible on or around the
area between the two doors. Position 'S'
(SUMMER) may be used during dry and less
humid conditions.
11